Stihl MS 271 Manual page 94

1
: Pull the throttle rod (1) out of the
guide (arrow) and put it to one
side.
Take care not to damage the fuel
hose when removing the carburetor
carrier.
: Push the manifold flange (1) out
of the carburetor carrier (2) in the
direction of the cylinder, pulling
the carburetor carrier away at the
same time.
1
: Remove the fuel hose (1) from
the guides (arrows)
– take care not to stretch the
hose.
MS 271 C, MS 291 C
– Remove the carburetor carrier,
check it and replace if necessary.
– Check the intake manifold and
replace if necessary, b 12.9
Installing
1
2
: To fit the manifold (2) through the
1
carburetor carrier's opening, wind
a piece of string (1) (about 15 cm
long) around the back of manifold
flange.
1
2 2
– Place the carburetor carrier in
position.
: Fit the fuel hose (1) in the
guides (2)
– take care not to stretch the
hose.
: Press the groove on the fuel
hose (1) fully into its seat (arrow).
The lug must engage the
2
seat (arrow).
2
: Use the ends of the string (2) to
pull the manifold flange (1)
through the intake opening while
pushing the carburetor carrier (3)
against the manifold flange.
– Remove the string.
2
: Position the carburetor carrier (1)
so that the semi-circles (arrows)
locate against the studs (2).
3
1
1
2
93