Stihl MS 271 Manual page 52

2
3
: Push the wiring harness (1),
terminal socket (2) and cable
lug (3) first, through the
hole (arrow).
2
– Use STIHL press fluid to simplify
assembly, b 14
: Push the rubber grommet (1) into
the bore in the engine housing (2)
until it is properly seated.
1
The ground wire (1) must point
towards the muffler and the short
circuit wire (2) towards the rear
handle.
MS 271 C, MS 291 C
1
The ground wire (1) must be
positioned in the guide under the
short circuit wire (2).
: Fit the ground wire (1) and short
circuit wire (2) in the
guide (arrow).
1
2
Ground wire: Crimped side of
terminal (1) must face the screw
head (2).
: Place the cable lug (1) in position
and fit the screw (2).
: Position the cable lug (1) so that
it points towards the cable guide
– hold it steady when tightening
2
and make sure it does not twist.
Short circuit wire: Crimped side of
terminal (3) must face the engine
housing.
: Connect the short circuit wire
terminal (3)
– the terminal must be pushed
fully home.
: Press the short circuit wire fully
into the guide (arrow).
2
1
1
2
: Lift the air guide shroud (1) a little
and push the ignition lead (2) into
position
– take care not to distort the air
guide shroud.
: Starting at the ignition module,
press the ignition lead (2) into the
guides (arrows).
1
– Install the carburetor carrier,
b 12.8
– Install the carburetor, b 12.5
3
1
: Push the contact spring (1) onto
the ground wire (2).
: Position the short circuit wire (3)
so that it is above the ground
wire's flag terminal (arrow).
– Fit the contact spring, b 7.7.4
– Install the filter base, b 12.3
3
2
51