Table of Contents
Advertisement
7. Run-Time, Capacity & Data
Press x3 without
Press & hold for
holding for software
version number...
version
After selecting to view the software version number, the battery will
enter Ship Mode automatically. Ship Mode reduces battery self-
discharge and can be used when you are going to store or ship your
batteries. To exit Ship Mode, link the battery to another active battery
or connect it to a charger that is powered-up.
Press x4 without
holding for computer
reset
Reset reverts the battery to its power-on state.
...which appears in
2 parts indicating
version 2.0
Press & hold to perform
reset. Do not release
until 3 lines disappear
7.3
In-Viewfinder Battery Status
Battery state-of-charge can be shown as a percentage of available
capacity in the viewfinder/LCD of cameras designed to accept this
data. Different data standards are used by camera and battery
manufacturers. Mini PAGlink batteries automatically adjust to support
the following: SMB (Sony and Red), I2C (IDX), analogue 0V to 5V
(Anton/Bauer).
When the batteries are linked, the data displayed is for the combined
capacity available. If there are 2 linked batteries, one at 100% SoC
and one at 60%, available capacity is 160% of 200%, which is equal
to 80%. It will always display as a fraction of 100%. If both batteries
were 100% the display would still say 100%.
If the data does not display, it could be because your camera has not
been set-up to communicate with the battery, or the camera mount
does not have the required contacts to deliver the information to the
viewfinder/LCD. Certain manufacturers do not include the data pins in
their V-Mount connectors.
80%
15
Advertisement
Table of Contents
