Table of Contents
Advertisement
Click "Device"- "Channels Names" in the menu bar of the main software interface, and the following Figure 7.19Channel
Name interface will pop up.
Figure 7.19 Channels name management
As shown in the figure above, after entering the new name of the channel in the corresponding channel, click the OK
button to save and update the name of the channel immediately. Note that the length of the channel name is limited to
5 English letters and numbers.
7.20 Channels copy
Click "Device"- "Channels Copy" in the menu bar of the main software interface, and the following Figure 7.20 Channels
Copy interface will pop up.
Figure 7.20 Channel Copy interface
As shown in the figure above, channel copy is to first select the source channel parameters of a source device and copy
them to the target channel of the same device or other target devices. Input channels and output channels cannot copy
each other. The left side is the corresponding channel, and the right side is the parameter to be copied. The "input" and
"output" buttons at the top of the interface can switch the channel type for copying.
Page 30 / 34
Advertisement
Table of Contents
