Part
Cover-Back
Belt
Motor
Figure
2
1
Description
• Unfasten the 6 screws that hold the back
cover in place. Remove the back cover by
sliding it down. (When assembling, slide the
back cover up.)
1. Remove the Cover back .
2. Separate the belt and then assemble it.
3. Check if the belt position is at the center of
the Pulley.
Assembling the belt :
Place the beltaround the Motor-Pulley
(①) and then over the Pulley (②).
1. Separate the wire housing from the motor.
2. Remove the bolts holding the motor at the
back of the washing machine.
3. Separate the motor.
Caution
When installing the belt around the motor
pulley, the bottom of the belt must be
located on the second tooth of the motor
pulley.
Disassembly and Reassembly _ 15