Leupold GX-2c Operating Instructions Manual page 22

TO INPUT THE TEMPERATURE AND ALTITUDE AT WHICH THE
STRIKING DISTANCE FOR EACH CLUB WAS MEASURED:
The procedure for inputting the temperature and altitude at
which each striking distance was measured begins immediately
after inputting the specific club distances . Follow each of the
steps under, "To Input The Striking Distance Of The 8, 6 and
4-iron" . Once the striking distances have been input, press MODE
and follow the steps below:
1) The last saved temperature will be flashing
in the bottom portion of the display . If you
wish to input a temperature other than the
one shown, proceed to step 2 . To save the
shown temperature, press MODE and skip to
step 3 below .
2) Press and release POWER to begin
incrementing through the temperature settings . The default
setting is 75 degrees F (25 degrees C) . Pressing POWER will
increase in 5 degree increments through a range of 30 degrees
to 120 degrees F (0 degrees to 50 degrees C) . When the
appropriate temperature is displayed, press and release MODE
to save your selection and move on to the altitude input .
3) The last saved altitude will be flashing in the bottom portion
of the display . If you wish to input an altitude other than the
one shown, proceed to step 4 . To save the shown altitude
19
M
Y
in
cm
ft