Table of Contents
Advertisement
Replacing the Lamp
When the time of use of the lamp exceeds 1,400 hours (2,300 hours for SX60), the following
message (two types) is displayed for 10 seconds each time the projector is turned on.
When the time of use is 1,400 to 1,500 hours:
(2,300 to 2,500 hours for SX60)
When the time of use is 1,500 hours or longer:
(2,500 hours for SX60)
This message will not be displayed again if you select [No] in response to the message "Do
you want to display this message again?".
You can check the time of use of the lamp in [Lamp counter] in the [System settings] menu
(P102).
When replacing the lamp, turn off the projector, wait until the cooling fan stops,
remove the power plug from the AC outlet, and let the projector stand for at least 1
hour. Otherwise, you may get burned because the main unit is very hot immediately
Caution
after the projector is turned off.
Do not touch the inner glass surface when you replace the lamp. Otherwise, the pro-
jector's performance may degrade.
Make sure to handle the lamp carefully and correctly since it may explode if it is
scratched or shocked.
Do not remove screws unless specified.
Replacing Lamp
This projector uses the following lamp.
Lamp type No.
SX6/X600: RS-LP02
SX60: RS-LP03
Be sure to use the specified lamp.
A lamp can be ordered from your dealer or Canon home page.
108
* [<], [>], the [OK] button, and the [POWER]
button are available during this message is
displayed.
* The [POWER] button is available during this
message is displayed.
Advertisement
Table of Contents
