Installation Of The Repeater And Transmitter - Tele System CRX2-R User Manual

INSTALLATION OF THE REPEATER AND TRANSMITTER

INSTALLATION OF THE REPEATER AND TRANSMITTER INSTALLATION OF THE REPEATER AND TRANSMITTER INSTALLATION OF THE REPEATER AND TRANSMITTER
To connect the equipment by inserting the CRX2
the audio/video equipments to control (remote position) and the CRX2
coaxial wall mount where is the leading original remote unit (leading position).
To position the extension IR of CRX2
to lead.
INSTALLATION OF THE REPEATER AND TRANSMITTER INSTALLATION OF THE REPEATER AND TRANSMITTER
INSTALLATION OF THE REPEATER AND TRANSMITTER INSTALLATION OF THE REPEATER AND TRANSMITTER
The receiver CRX2 CRX2- - - - R R R R has a trimmer to regulate the amplitude of 11 MHz coaxial signal.
CRX2 CRX2
This feature allows to balance out the losses of the distribution coaxial cable system.
We advice to start with the maximum amplitude of signal, decresing it progressively to
cancel possible interferences in the DVB-T TV signal.
The passing band of some TV tap/splitter could be in the range 47-860MHz.
Some TV tap/splitter have no return channel ( 5-47 MHz ) necessary to work properly.
These two limits involves possible strong attenutations in the coaxial signal
compromising the quality of signal.
We advice to substitute all TV taps/splitters with more recent models with frequency
range 5- 860 MHz and return channel.
The flashing of led in the CRX2
indicates the corrected working of equipments.
CRX2- - - - T T T T in the coaxial wall mount TV near to
CRX2 CRX2
CRX2- - - - T T T T in the front of the remote audio/video equipment CRX2 CRX2
CRX2- - - - T T T T unit when the original remote unit is transmitting CRX2 CRX2
7
CRX2- - - - R R R R in the TV
CRX2 CRX2