First Time Installation - Tele System TS6700 T2HD User Manual

TELE System

3 First time installation

When all the connections on the receiver are ready (section 2.2) and the mains lead is plugged in, the
receiver will start up automatically. If this does not happen, press the q button on the front panel of the
receiver or on the remote control.
An easy installation menu will be displayed where you can set different parameters and then run the channel
scan:
Step 1. Region
Use the arrow ◄/► buttons to select your Country. Press ▼ to proceed.
CAUTION
If the wrong country is selected the channel scan may not detect all the channels available.
Step 2. Language
Use the arrow ◄/► button to select a language for the On Screen Display menu (OSD). Press ▼ to go to
the next parameter.
Step 3. Display Mode
Adjust the video resolution of the HDMI output with arrow ◄/► button, taking care about the technical
characteristics of the connected TV monitor. Push ▼ to go down.
Step 4. Aspect Mode
With arrow ◄/► button set the video aspect ratio between:
1. 16:9FS: for 16:9 screen, it extends the video picture to the whole screen,
2. 16:9PB: for 16:9 screen, in case of 4:3 video picture it adds left and right black bars to cover all screen,
3. 4:3 PS (Pan Scan): for 4:3 screen, in case of 16:9 video picture it fills the screen vertically and cuts the
exceeding lateral sides,
4. 4:3 LB (Letter Box): for 4:3 screen, in case of 16:3 video picture it adds up and down black bars to cover
all screen.
Press OK to proceed.
4
TS6700 HD