Recording Still Images On A Memory Card - Canon optura10 Instruction Manual

Recording Still Images on a Memory Card

You can record still images with the
camcorder, from a tape in the camcorder
( 108) or from devices connected via the
DV terminal or AV terminal (
❍ Do not turn off the camcorder, disconnect the power source or remove the
memory card while the card access display (<<< or >>>) in the upper right
corner of the screen or the card access indicator is flashing. Doing so could
result in data damage.
❍ When you are using a SD Memory Card, make sure that the protect switch is
set to allow recording.
Make sure to insert a memory card with enough remaining capacity.
Recording with the Camcorder
In autofocus mode, the camcorder keeps focusing automatically. Furthermore, this
camcorder is equipped with the Focus-Priority mode for even more accurate focus. In
Focus-Priority mode, you can choose between three focusing points (
However, you can turn off the Focus-Priority mode if you wish to put timing ahead of
focusing ( 107).
When the program selector is set to
center focusing point available).
CAMERA
1. Set the camcorder to CARD CAMERA mode.
A white focusing frame appears in the center of the screen. The camcorder will focus on
the subject in the center of the screen. To change the focusing point, see Selecting a
Focusing Point (
2. Press the PHOTO button halfway.
• F and focusing frame turn green when focus is adjusted. The
beep sounds twice. The picture may appear out of focus for a
moment while the camcorder is focusing.
• Exposure is locked.
• Focus can be adjusted manually with the focus ring when the PHOTO button is pressed
halfway.
• When you press the PHOTO button on the wireless controller, recording starts immediately.
109).
[, the Focus-Priority mode is set to ON (only the
PLAY (VCR)
106).
PHOTO button
Card access
indicator
CARD CAMERA
106).
CARD PLAY (VCR)
E
105