Table of Contents
Advertisement
Note: With the addition of another strobe, depending on conditions, there is a good chance of
overexposing the image as the total minimum output of all the strobes may be too much at close
distances. Here are some countermeasures:
Attach optional D-180 –0.5 diffuser to strobe to reduce flash output
Stop down camera aperture
Move strobe farther away from subject
Use Clear Photo System on internal strobe
D-180 Preparation
Setting the Advanced Cancel Circuit
Caution: Before setting Advanced Cancel Circuit always turn Main Mode Switch to OFF.
For R-TTL , R-S , R-M Group Cameras
Turn the Advanced Cancel Circuit to OFF by installing the magnet into the Advanced Cancel
Circuit Switch.
Installation Method
1) Insert the magnet into the Advanced Cancel Circuit Switch hole
2) Thread in and screw down the Magnet Switch Screw
Caution: Screwing down the Magnet Screw too tightly will damage
the strobe. Use the "Magnet Screw Tightner" as shown in picture to
screw down Magnet Screw so it is not quite snug, almost loose, but
definitely not tight.
For all Group Cameras other than R-TTL , R-S , R-M leave the
Advanced Cancel Circuit ON, by not installing the magnet.
Installing Batteries
Caution: Whenever installing batteries always turn Main Mode Switch to OFF.
Note:
Whenever opening or closing Battery Box outer cap always check condition of Battery
Box O-ring, O-ring groove contact surface and O-ring contact surface on inside of cap.
Check for debris or damage, and clean/re-grease/replace O-ring as necessary.
The D-180 can use the following batteries:
INON D-180 Manual
Version 1.
October 4, 2003
Copyright 2002, 2003 by INON America, Inc. All rights reserved.
AA Alkaline Batteries x 4
AA NiCad batteries (nickel cadmium) x 4
AA NiMH batteries (nickel metal hydride) x 4
34
Advertisement
Table of Contents
