Table of Contents
Advertisement
Caution: To avoid strobe damage, or accidents including personal injury, do not use Lithium,
Manganese or other non-specified batteries.
1) Slowly unscrew the Battery Box
outer cap counterclockwise.
2) Unscrew the Battery Box inner cap
screw counterclockwise and remove
the Battery Box inner cap.
3) Install the batteries in proper
position, paying attention to the +/-
indications on the inside of the
battery box.
4) Align
depression on the Battery Box inner cap with the index ridges on the inside of the
Battery Box, and screw down the battery box inner cap screw.
5) After once again checking the battery box O-ring and contact surface, slowly screw
down the battery box outer cap clockwise.
Connecting to Camera System
Connecting with "Optical D Cable", "Optical Slave Cable" or Optical D
Slave Cable:
1) Select the appropriate Optical Cable for your camera/housing/master
strobe system. Then, following the instructions provided with the
cable, connect to your system accordingly.
2) Place Sensor Plug end of Optical Cable directly over the Optical Sensor, lightly push on, and
screw down until lightly snug, but not too tight.
Attaching to Camera/Housing System
Caution: Whenever attaching to or removing from arm or system base always turn Main Mode
Switch to OFF.
Follow the instructions provided with your arm system / system base.
Note that improper use of screws or washers may result in damage to
the D-180.
Recommend attachment methods:
1) Inon "Z Adapter" for attaching Inon or Ultralite arm systems.
2) Inon "YS Adapter Fixing Bolt" for attaching with standard 12mm "YS Adapter".
INON D-180 Manual
Version 1.
October 4, 2003
Copyright 2002, 2003 by INON America, Inc. All rights reserved.
the
V-shaped
index
35
M
a
i
n
t
a
i
n
G
a
p
H
e
r
e
M
a
i
n
t
a
i
n
G
a
p
H
e
r
e
Advertisement
Table of Contents
