Canon INON D-180 User Manual page 28

Underwater auto-strobe
Table of Contents

Advertisement

11. "TTL" OK Green Lamp
When the strobe light adjustment mode is set to External Auto, and the image is taken and
exposed properly within the "External Auto Exposure Adjustment Range" the lamp will shine
green. But if the subject is not within the range, for example, too far away for the strobe light to
adequately reach, causing the strobe to emit a full discharge, then the lamp will not shine.
12. Battery Box
Caution: Be very careful that no water enters the Battery Box or contacts the terminals on
the Battery Box Inner Cap. If even one small drop of water enters for even a short period of
time it may result in an electrical short, corrosion damage, cause buildup of flammable gas,
lead to explosion or other accident. In particular, when removing the Battery Box Outer
Cap, follow these precautions:
1. First rinse with fresh water and dry area around the Battery Box. (Assuming
strobe is wet with salt water)
2. To prevent any water from entering the Battery Box, hold the Battery Box so the
Battery Box Outer Cap is facing down.
3. Also, unscrew the cap slowly.
13. Battery Box Inner Cap
14. Battery Box Inner Cap Screw
15. Battery Box Outer Cap
The D-180 can use the following batteries:
AA Alkaline Batteries x 4
AA NiCad batteries (nickel cadmium) x 4
AA NiMH batteries (nickel metal hydride) x 4
Caution
:
To avoid strobe damage, or accidents including personal injury, do not use
Lithium, Manganese or other non-specified batteries.
16. 6mm threaded socket for Z-Adapter or YS Adapter/YS Adapter Fixing Bolt
20.
Battery Box Spare O-Ring
21.
Inon Grease
INON D-180 Manual
Version 1.
October 4, 2003
Copyright 2002, 2003 by INON America, Inc. All rights reserved.
28

Advertisement

Table of Contents
loading

Table of Contents