VWR PCR Workstation HEPA Quick Start Manual page 4

ASSEMBLING THE PCR WORKSTATION
The PCR Workstation should be assembled by two people, directly at the site of operation. We
recommend to wear safety gloves for the protection of hands.
Step 1
Put the base  on an even surface with the
rubber feet facing down and the sensor
cable outlet facing to the front. Lay the back
panel  onto the base  with the power
outlets facing down, and the power input and
the type label facing to the right.
Connect both sensor cables.
Caution of dangerous voltage
Ensure that the voltage requirements of the PCR Workstation exactly match your local AC
power supply.
Only use the original AC cable supplied with the PCR Workstation.
Caution of liquids
Ensure that no liquids can enter the device. Do not place liquids on top of the PCR
Workstation.
Caution of dangerous explosive material
Do not use reactive or explosive substances in the PCR Workstation.
Caution of damages
Check for transport damages and completeness of the accessories upon arrival. If any
damage is noticed, contact your distributor or manufacturer immediately. If you detect any
damages of the PCR Workstation or one of its accessories, do not connect the PCR
Workstation to the AC wall outlet and do not use the device in any manner!
Caution of optical radiation
Do not switch on the PCR Workstation if not completely assembled. See "ASSEMBLING
THE PCR WORKSTATION", page 4.
Do not look directly into the UV lamps.
Base 
Back panel 