Kohler CORALAIS K-15290 Manual page 6

NOTE: The following step is applicable to a tile covered
rough deck installation only.
Slide the washer, flat side facing forward, on the supply
tube.
NOTE: The washer is not needed for rim/finish deck
installation.
Back off the setscrews in the sleeve, and with a twisting
motion install the sleeve on the spout supply tube until it
contacts the washer surface.
Align the sleeve so the setscrews are not facing directly
forward or backward.
Tighten the setscrews.
Install the spout assembly onto the sleeve, and carefully
press down until the spout base contacts the finished
deck surface.
Align the spout as desired, and tighten the setscrew.
If included, press the plug button into the setscrew hole.
B
1012829-2-
Washer
Spout
Supply
Tube
Sleeve
Spout
Assembly
Plug Button
Setscrew
Finished
Deck
6
Finished
Deck
Rough
Deck
Fig. #14
Setscrew
Setscrew
Fig. #15
Sleeve
Fig. #16
Kohler Co., Kohler WI, U.S.A.