Subscribe to Our Youtube Channel
Related Manuals for Aybey Elektronik EVOS Series
Summary of Contents for Aybey Elektronik EVOS Series
- Page 1 APPENDIX-3 LANDING OPERATION PANEL INSTALLATION EVOS SERIES SERIAL COMMUNICATION LOP INSTALLATION MANUAL Document Version: v1.03...
- Page 2 ADDITIONAL SECTIONS: EK04-1-Display CLC/CLT/CLP EK04-2-Display SYC/SYT/SYP EK04-3-Display DMCx/DMTx/DMPx Figure 1 Figure 2 Figure 3 EVOS LOP Content • EVOS Serial Communication LOP • Mounting Dowels and Screws • Installation and Usage Manuals...
- Page 3 1- Mechanical Installation Press the spring mechanism at the bottom of EVOS LOP with a screwdriver and open the front cover. Mark the cable screw holes by placing the backplate where you want to install. • Drill holes for M6.5 dowels. (as shown by “X”...
- Page 4 2- Electrical Connections Figure 4 Figure 5 1 Connect the CANBUS cable terminals of the LOPs to the corresponding socket on the control panel. (100-1000-CL1-CH1). 2.2 If your system has a pit control unit with CAN interface as shown in Figure 4, connect all LOPs to this unit wth CAN-BUS cables with dual white rectangular sockets.
- Page 5 4-Caution 4.1 Use only special stainless steel cleaners to clean the panels. 4.2 Do not use any detergent or acids to clean panels. 4.3 Avoid to contact any liquid to the LOP. 4.4 In case of an electrical failure, switched off the LOP and contact with Aybey Elektronik Technical Service.
Need help?
Do you have a question about the EVOS Series and is the answer not in the manual?
Questions and answers