Preliminary Inspection; Installation Instructions - Raynor ControlHoist 2.0 Standard Installation Instructions And User Manual

Before proceeding with the installation of your Raynor Jackshaft Operator, it is advisable that you check the following
items:
PACKAGING
Check shipping container for damage. Notify delivering
carrier immediately.
VISUAL INSPECTION
Visually inspect all parts of the operator for shipping
damage.
Many of the problems related to electric operators are due to improper installation. The following installation procedures
are recommended to minimize these problems.
UNPACKING
This unit is shipped in one carton containing the operator
itself, one drive and one driven sprocket, one length of
chain, one control station, and one package of small
hardware. Unpack carton being certain that all loose
parts are removed before discarding packing material.
Position #4
May be wall mounted in one of the
Above the shaft - left or right hand drive
Below the shaft - left or right hand drive
Above the shaft center mount -
recommended for doors over 18' wide
Jackshaft operators with hand chains
can not be used in the center position.
Operator extends out
from wall 11".
Position #5
5973130-4

PRELIMINARY INSPECTION

INSTALLATION INSTRUCTIONS

MOUNTING POSITIONS
following five positions:
SPRING SHAFT
Opening Width
Check the nameplate located on the powerhead to verify
that the correct operator was shipped to you. Also check
the power source available and compare it with the
electrical data on the nameplate.
MOUNTING POSITION
WARNING: This operator has been ordered for a
specific mounting position. Because of differences in
motor rotation, do not install operator in any position
other than that for which it was ordered without first
contacting the factory. See Fig. 1 below.
Position #3
HEADROOM
39" maximum headroom is
allowed; measured from the
center point of the
spring shaft.
Door Headroom
FIG. 1
Position #2
13"
SIDEROOM
20" of sideroom required;
measured from the inside edge
of the opening
6-1/2"
20"
Position #1
24"