Preliminary Inspection - Raynor ControlHoist 2.0 STANDARD Installation Instructions And User Manual

Before proceeding with the installation of your Raynor Trolley Operator, it is advisable that you check the following items:
PACKAGING
Check shipping container for damage. Notify delivering
carrier immediately.
VISUAL INSPECTION
Visually inspect all parts of the operator for shipping
damage.
This operator as shipped contains one carton and a rail assembly. The carton contains the powerhead, trolley carriage,
door arm, fasteners and miscellaneous parts. The rail assembly includes the roller chain.
RAIL AND CARRIAGE ASSEMBLY
Unpack powerhead and trolley rail assemblies being
certain that all loose parts are removed before discard-
ing packing material.
Slide trolley carriage (A), Fig. 1, all the way forward on the
rail assembly with lug (B) facing the open end of the rails
and within 6" of front mounting bracket.
RAIL ASSEMBLY
5/16" x 3/4" FLAT HEAD BOLTS 5/16" x 3/4" FLAT HEAD BOLTS
& WHIZ LOCK NUTS & WHIZ LOCK NUTS
5973129-4

PRELIMINARY INSPECTION

ASSEMBLY INSTRUCTIONS
FRONT MOUNTING BRACKET
TROLLEY CARRIAGE (A)
LUG (B)
FIG. 1
POWERHEAD
FIG. 2
Check the nameplate located on the powerhead to verify
that the correct operator was shipped to you. Also check
the power source available and compare it with the
electrical data on the nameplate.
ATTACH POWERHEAD Fig.2
Bolt powerhead to rail assembly using 5/16 x 3/4 flat-hd
bolts and whiz lock nuts furnished in hardware package.
Tighten all bolts securely.
ASSEMBLE CHAIN Fig. 3
Apply 3/8" hex nut furnished in hardware package to
adjustment rod (C) and install chain around front idler
sprocket at front of rail assembly and feed under trolley
rail brackets to drive sprocket on powerhead. Feed
adjustment rod around drive sprocket then back to trolley
carriage. Install lock washer and feed through lug (B) of
carriage just far enough to start second nut. Thread other
end of chain through chain keeper (E) as shown.
Warning! Improper lead in of chain could cause
damage to door, operator or personnel.
Take up slack in chain and tighten cap screw (D). Make
final adjustments of chain tension by adjusting nuts on
rod (C).
CHAIN KEEPER (E) CHAIN KEEPER (E)
LUG (B)
5/16" x 1" CAP SCREW (D)
TROLLEY CARRIAGE (A)
ADJUSTING
ROD (C)
LOCK WASHER
3/8" HEX NUT
FIG. 3