Transport, Storage And Disposal; Warranty - Madas IT262.00 Manual

DN 200 - DN 250 - DN 300 (see fig. 2 and 3):
• Use the knob (2), to insert the eccentric ring nut (8) with the larger part of the half moon on the left and the fastening
grub screw holes facing up;
• Secure the eccentric ring nut (8) by tightening the 2 grub screws (12);
• Loosen the 2 screws (9) of the upper cover (11);
• Secure the support bracket (7) of the micro switch (5) to the upper cover, using the screws (9);
• Tighten or loosen the micro switch (5) for calibration so that when the solenoid valve is closed, the micro switch's pin (4) is pressed;
• Secure the micro switch (5) in that position by tightening the 2 threaded grub screws (6);
• The kit is now installed. Reset and close the solenoid valve (by cutting off the power) to make sure the microswitch is
signalling correctly. Repeat the operation 2-3 times;
• Position the cover of the knob (3) and secure it in that position with the screw (10).

3.0 - TRANSPORT, STORAGE AND DISPOSAL

• During transport the material needs to be handled with care, avoiding any impact or vibrations to the device;
• If the product has any surface treatments (ex. painting, cataphoresis, etc) it must not be damaged during transport;
• The transport and storage temperatures must observe the values provided on the rating plate;
• If the device is not installed immediately after delivery it must be correctly placed in storage in a dry and clean place;
• In humid facilities it is necessary to use driers or heating to avoid condensation.
• At the end of its service life, the product is to be disposed of separately from other waste (WEEE directive 2012/19/EU)
and in compliance with the legislation in force in the country where this operation is performed.

4.0 - WARRANTY

The warranty conditions agreed with the manufacturer at the time of the supply apply.
For damage caused by:
• Improper use of the device;
• Failure to observe the requirements described herein;
• Failure to observe the regulations pertaining to installation;
• Tampering, modification and use of non-original spare parts;
are not covered by the rights of the warranty or compensation for damage.
The warranty also excludes maintenance work, other manufacturers's assembling units, making changes to the device and natural wear.
10