Page 9
500ml Salt consumption When you run the dishwasher, the water softener will be full of water. Therefore, adding softening salt should always be done immediately before you start the unit. Check the salt level to ensure it is enough before starting one of the complete washing programs and ensure 500ml of water has been added.
Page 10
The unit is equipped with a function that you can adjust the frequency to release the salt to the water softener. This is further to the selector on the salt container. The default setting is H4. IMPORTANT : YOU SHOULD SET THIS VALUE ACCORDING TO THE WATER HARDNESS OF YOUR AREA BEFORE THE 1 USE.
Page 16
Standard daily cycle for normally soiled loads, such as pots, plates, glasses.
Page 17
Close the door,press the power button. 5. Continue to press "program" button to select the desired "wash cycle". (See the section entitled “ Wash Cycle Table”). Press "start/pause" button to start the program. Then turn it on by press "power" button again, table Press "start/pause"...
Page 18
Program End 1.When the washing program is finished, it will sound 6 times and displays ''- - ''. 2. Open the door and remove all the dishes. 3.Turn off the unit by pressing the Power switch. Then close the door. 4.
Page 21
Technical specifications (according to EU Directive 1059/2010) Brand BUSH Model DWFS146W Capacity 14 settings Energy efficiency class Annual energy consumption 266kWh Energy consumption of the standard cleaning cycle 0.93 kWh Power consumption of off-mode/left-on mode 0.35W/0.9W Annual water consumption 3080 litre...
Need help?
Do you have a question about the DWFS146W and is the answer not in the manual?
Questions and answers