Table of Contents
Advertisement
Maintenance
It is important to keep your bath clean. Not only will contaminated liquid
reduce the performance of the bath, it may also damage it. Change the
cleaning liquid regularly. Your cleaning process will determine how often to
change the liquid – the more soiled your items, the more often you will need
to change the liquid.
Before cleaning the equipment always switch off and disconnect it from the
power supply and allow it to cool down to less than 40
with a damp soapy cloth.
The base of the bath generates the ultrasonic activity by vibrating at very
high speeds. If any contaminants are in contact with the bath, they act as an
abrasive, causing wear on the metal surface. In extreme cases, the bath will
develop holes and start to leak.
Portable Appliance Testing should be conducted with water in the bath.
Service
Ultrawave recommend that your Q-Series ultrasonic bath is serviced and
tested by an Ultrawave approved engineer on an annual basis.
More regular periodic testing can be done by the operator to ensure that
your ultrasonic bath is operating at optimum efficiency.
There are no user serviceable parts inside the unit. All service and repair must
be conducted by suitably trained and qualified engineers approved by
Ultrawave.
Service contracts for your Q-Series ultrasonic bath are available from
Ultrawave.
For more information on Ultrawave Service Contracts, Annual Validation
Testing, and any maintenance, contact the Ultrawave After Sales
Department:
Tel:
e-mail:
Q-Series Operating Manual
+44 (0) 29 2083 7337
service@ultrawave.co.uk
33
°C. Clean by wiping
C6012106
Advertisement
Table of Contents
