This warranty shall be governed by the laws of the State of California. In the event the defect is determined to be within the terms of this warranty, then ROS agrees to repair and/or replace (at ROS’s discretion) the product or defective portion at no charge to the Purchaser.
CUSTOMER SERVICE ROS, Inc uses a worldwide network of stocking distributors and representatives who are familiar with our products and are able to provide assistance during installation and/or operation of these products. If you have any questions or problems with this product that are not covered by this manual or instruction, please contact our agent in your area, or contact us directly by phone, fax, or e-mail.
GENERAL DESCRIPTION The HPS-1000 Droplight System was designed specifically for use in nuclear reactor vessels and spent fuel storage pools. The light head uses a high-pressure sodium discharge light. Because of the very high efficiency, the 1000-watt HPS lamp produces the equivalent light of seven 1000-watt incandescent lights and will last ten times as long as an incandescent light used under the same conditions.
DESIGN FEATURES The primary design features of the HPS-1000 Droplight System are as follows: 1. Exceptionally long life (10 times longer than an incandescent bulb). 2. Very high efficiency (140,000 lumens for 1000 watt light). 3. Direct plug in replacement of existing fixtures. 4.
If damage is detected a claim should be submitted to the freight carrier, with a copy to ROS, Inc. After the initial inspection, connect and operate the equipment as instructed in the following section.
MAINTENANCE The HPS-1000 Droplight system was designed to provide a long lifetime of service with very little maintenance. Maintenance is generally limited to cleaning and replacement of bulb assemblies. Ballasts are generally good for 5-7 years. After this period, the capacitor may change value due to heat and age or the striker may give out.
CAUTION LAMP AND STAINLESS STEEL SCREEN MAY BE VERY HOT AFTER PROLONGED OPERATION. EITHER WAIT FOR SCREEN AND BULB TO COOL OR USE PROTECTIVE GLOVES TO CHANGE LAMP ASSEMBLY. USE OF AN INCORRECT POWER SOURCE MAY CAUSE PERMANENT DAMAGE TO THE BALLAST POWER SUPPLY. DO NOT PLUG OR UNPLUG INTERCONNECT CABLES WITH THE POWER ON.
Need help?
Do you have a question about the HPS-1000/Q and is the answer not in the manual?
Questions and answers