Safety And Compliance; Electromagnetic Fields (Emf); Fcc And Ic Information - Philips HF3650 User Manual

English
22
Problem
I am unable to stream
music via USB.
The AUX inlet doesn't
work properly.
Suddenly the device
makes a beeping
sound.

Safety and compliance

Electromagnetic fields (EMF)

FCC and IC information

Solution
The USB connection is only for charging your mobile phone. You are not
able to stream music to the Sleep & Wake-Up Light.
Try to set the volume on your mobile phone either higher or lower. If
necessary, adjust the volume level on the appliance as well.
The backup alarm went off. The internal clock and the back-up alarm
remain active for at least 8 hours. If an alarm is due during this back-up
period, it will go off. The alarm sound stops automatically after
approximately 30 seconds. You also can stop the alarm sound
immediately by connecting the appliance to the power briefly.
To prevent the back-up alarm from going off when the power is
disconnected (e.g. during storage), disable the alarms before you
disconnect the appliance from the power.
This appliance meets the safety requirements in the USA and Canada for:
- UL 153, CSA C22.2 No. 250.4 (Portable Electric Luminaires)
- UL 62368-1, CSA C22.2 No. 62368-1:19 (Audio/Video, Information and
Communication Technology Equipment)
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
- This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules and
Canadian ICES-003 and ICES-005 standards. These limits are designed
to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.