Parameter Settings - A&D GX-A Series Maintenance Manual

6.11 Parameter Settings

1. Serial number setting
Follow the procedure below to set the serial number.
Step 1. Display the function setting mode
on page 28,29.
Step 2. Press the SAMPLE key twice.
Step 3. Press the PRINT key. Then the display starts to blink.
Step 4. Using the following keys, input the serial number on the label attached to the each
balances.
RE-ZERO key: changes the value of the blinking digit （＋） .
MODE key:
SAMPLE key:
CAL key :
Step 5. When the serial number is set, press the PRINT key.
end
Step 6. is displayed to indicate that the operation is completed.
GX-A/GF-A Maintenance manual
Unit ,
5n
is displayed.
changes the value of the blinking digit （－）.
changes the blinking digit position.
cancels the operation
Page 46
after getting into check mode shown