Replacing The Memory Card Reader - Gateway GM5260 Hardware Reference Manual

CHAPTER 3: Maintenance Basics

Replacing the memory card reader

Tips & Tricks
You need a Phillips screwdriver to replace
the memory card reader.
Important
The color and shape of your replacement
card reader's front cover may vary from
your original card reader.
20
Remove the two drive retention screws, then slide the drive forward and
6
out of the drive bay.
Slide the new drive into the drive bay, line up the screw holes on the drive
7
bay with the screw holes on the drive, then replace the two drive retention
screws.
Reconnect the drive cables using your notes from
8
Replace the front bezel by following the instructions in
9
front bezel" on page
Replace the side panel by following the instructions in
10
panel" on page 16.
To replace the memory card reader:
Remove the side panel by following the instructions in
1
panel" on page 14.
Remove the front bezel by following the instructions in
2
front bezel" on page
If you are installing a new card reader (not replacing an old one), remove
3
the two drive retention screws in the drive bay, then go to
location of the screws, see the photo in
Drive retention screws
Drive retention screws
16.
15.
Step
www.gateway.com
Step 4.
"Replacing the
"Replacing the side
"Removing the side
"Removing the
Step 6. For the
6.