Boss GX-100 Reference Manual page 52

Footswitch and Expression Pedal Settings
Parameter
TIME *1
CURVE *1
WAVE FORM *2
PEDAL(P.66)
RATE *2
MIDI CH *3 *4
TARGET MIDI CC#
CC# *3 MIN
MAX
TARGET MIDI PC#
PC# *4
MSB
LSB
*1 The INTERNAL PEDAL TRIGGER, INTERNAL PEDAL TIME, and INTERNAL PEDAL CURVE parameters are enabled when the SOURCE
parameter is set to INT PEDAL.
*2 The WAVE PEDAL FORM and WAVE PEDAL RATE parameters are enabled when the Source parameter is set to WAVE PEDAL.
*3 The MIDI CH, TARGET MIDI CC# parameters are enabled when the TARGET is set to MIDI CC.
*4 The MIDI CH, TARGET MIDI PC# parameters are enabled when the TARGET is set to MIDI PC.
52
Value
NUM1–NUM4 This is activated when the [1]–[4] switch is operated.
CUR NUM This is activated when you operate the same number switch as the selected
memory number.
EXP 2 This is activated when an external expression pedal connected to the CTL 3,
4/ EXP 2 jack.
CTL 1, CTL 2 This is activated when the [C1]–[C2] switch is operated.
CTL 3, CTL 4 This is activated when an external footswitch connected to the CTL 3, 4/
EXP 2 jack is operated.
BANK à
This is activated when the BANK [Ç] switch is operated.
BANK á
This is activated when the BANK [É] switch is operated.
CC#1–31, 64–95 This is activated when a control change is received.
0–100 This specifies the time over which the internal pedal will move from the
toe-raised position to the toe-down position.
LINEAR
SLOW RISE
FAST RISE
SAW
TRI
SINE
0–100, This determines the time spend for one cycle of the assumed EXP Pedal.
BPM ŀ–Ō
* When set to BPM, the value of each parameter will be set according to the value of the
"MASTER BPM" specified for each memory. This makes it easier to achieve effect sound
settings that match the tempo of the song.
* If, due to the tempo, the time is longer than the range of allowable settings, it is then
synchronized to a period either 1/2 or 1/4 of that time.
SYSTEM Transmits a message on the MIDI channel specified by the parameter TX
CHANNEL in "MIDI SETTING."
1–16 The message is transmitted on the specified MIDI channel.
0–127 The message is transmitted using the specified controller number.
0–127 Selects the minimum value of the transmitted CC# message.
0–127 Selects the maximum value of the transmitted CC# message.
1–128 Specifies the program number that is transmitted.
OFF, 0–127 Specifies the bank select MSB that is transmitted. If this is OFF, the bank
select MSB is not transmitted.
OFF, 0–127 Specifies the bank select LSB that is transmitted. If this is OFF, the bank
select LSB is not transmitted.
Explanation