Tripp Lite N48M Series Installation Manual page 3

Ultra high-density fiber panel all-in-one solution

Hide thumbs Also See for N48M Series:

Available languages

Installation

Place the panel into position in an enclosure or open

frame rack. Align the mounting holes and use rack-

mounting screws (2 per side, not included) to secure the

unit.

Locate the appropriate MPO cable. Remove the Velcro strap, uncoil and pull cable, as required. Excess cable slack can be

recoiled inside the panel.

Cables are labeled

per port in both

meters and feet.

To access the MPO cables, untighten the two handscrews

located on the rear of the unit

and flip down the rear access plate

Available rear-to-front

cable access.

, lift the top panel

Table of Contents