Johnson Controls FCP-PA-701-NF Quick Start Manual page 4

FCP-PA-701-NF
Figure 9: Conventional PTAC
Setup and adjustments
Preset configuration profiles
The FCP thermostat includes 20 preset configuration profiles. You can use these profiles to quickly configure essential settings, such as
system type, remote sensor, and pipe sensor.
The thermostat screen shows the preset configuration menu on the first power up or after a factory reset. To select a configuration
profile, use the Up or Down buttons to scroll through the configuration profiles, then press Mode to confirm your selection. The following
table lists the preset configuration profiles.
Table 2: Preset configuration profiles (part 1 of 2)
Profile # Remote Pipe
sensor sensor
1 Yes Yes
2 Yes Yes
3 Yes Yes
4 Yes Yes
5 Yes No
6 Yes No
7 Yes No
8 Yes No
9 No Yes
10 No Yes
11 No No
12 No No
13 No No
14 No No
15 Yes No
System 2-pipe Available modes:
type FCU with
1: Heat only
aux heat
2: Cool only
3: Heat and cool with auto
4: Heat and cool without auto
2-pipe FCU Yes 3
2-pipe FCU Yes 3
2-pipe FCU No 4
2-pipe FCU No 4
2-pipe FCU Yes 3
2-pipe FCU Yes 3
2-pipe FCU No 4
2-pipe FCU No 4
2-pipe FCU No 4
2-pipe FCU No 4
2-pipe FCU No 4
2-pipe FCU No 4
2-pipe FCU Yes 3
2-pipe FCU Yes 3
4-pipe FCU - 3
4
Pipe state Pipe state: Purge
- calendar frequency:
0: Heat
0: Never
1: Cool
1: 2 hours
2: 24 hours
Off - 1
Off - 0
Off - 1
Off - 0
Off 0 -
On - -
Off 0 -
On - -
Off - 1
Off - 0
Off 0 -
On - -
Off 0 -
On - -
- - -
LIT-12013797