Appendix Development Tools - NEC mPD78C14 A Schematics

APPENDIX DEVELOPMENT TOOLS

The following development tools are provided for system development using the µ PD78C14(A):
Language processor
87AD series This relocatable assembler is a program which converts a program written in mnemonics
relocatable assembler into object code that can be executed by microcontroller.
(RA87) In addition, it contains the automatic function of symbol table generation and branch
instruction optimization processing.
Host machine
PC-9800 series
IBM PC/AT
PROM write tools
Hard- PG-1500 PG-1500 is a PROM programmer which enables you to program single chip microcontrollers
ware containing PROM by stand-alone or host machine operation by connecting an attached
board and optional programmer adapter to PG-1500. It also enables you to program typical
PROM devices of 256 Kbits to 4 Mbits.
PROM programmer adapter for the µ PD78CP14(A) and connected to PG-1500 for use.
PA-78CP14GQ
Soft- PG-1500 PG-1500 and a host machine are connected by a serial or parallel interface and PG-1500 is
ware controller controlled on the host machine.
Host machine
PC-9800 series
IBM PC/AT
Note Ver. 5.00/500A have task swap function. However, this function is not supported by this software.
Remark Operations of the assembler and PG-1500 controller are guaranteed only on the host machines under the
operating systems listed above.
OS
TM
MS-DOS
(Ver. 2.11 to Ver. 5.00A
TM PC DOS TM
(Ver. 3.1)
*
OS
MS-DOS
(Ver. 2.11 to Ver. 5.00A
PC DOS
(Ver. 3.1)
µ PD78C14(A)
Distribution media
3.5-inch 2HD
Note ) 5-inch 2HD
3.5-inch 2HC
5-inch 2HC
Distribution media
3.5-inch 2HD
Note
) 5-inch 2HD
3.5-inch 2HD
5-inch 2HC
*
Ordering code
(product name)
µ S5A13RA87
µ S5A10RA87
µ S7B13RA87
µ S7B10RA87
Ordering code
(product name)
µ S5A13PG1500
µ S5A10PG1500
µ S7B13PG1500
µ S7B10PG1500
49