Assembly - DeWalt DW168F Manual

Assemble recoil Starter
waRnIng: Risk of unsafe operation. Always wear gloves and certified safety equipment:
ANSI Z87.1 eye protection (CAN/CSA Z94.3) with side shields when assembling and
disassembling.
1. Slide the starter rope (G1) through
the starter reel (A1) and tie a knot
(N1) in the rope as shown. Wind the
starter rope around the starter reel
in the direction of the arrow.
noTE: Leave approximately 12"
(30 cm) of starter rope outside the
starter reel.
2. Place the hook (P1) on the outer side
of the spring (ZZ) into the groove
(O1) inside the starter reel (A1).
3. Place the starter reel on the recoil
cover so the spring inner hook hooks
to the case tab.
4. while holding the recoil cover, rotate
the starter reel two revolutions in the
direction of the arrows for prelimi-
nary winding.
G1
A1
N1
O1
P1
ZZ
A1
5. Slide the starter rope end through
the recoil cover rope guide and pull
it outwards. Pass the starter rope
through the starter grip (Q1) and tie
a knot in the rope as shown. noTE:
Rope will be under tension, clamp
rope with vise or similar devise to
hold rope while tying.
waRnIng: Risk of unsafe operation.
Do not separate the starter reel from the
recoil cover. If they are separated the
return spring inside the case will come off
and could cause serious injury.
6. Install the ratchets (E1) with the
friction springs (C1), snap ring (M1)
and reel cover (D1). Tighten reel
cover bolt (F1).
7. Pull the starter rope several times to
check the operation of the ratchet.
noTE: Ratchet should extend
outward while pulling starter rope
and then retract.
29
Q1
f1
m1
D1
E1
C1