Getting Started
To turn on Simulator mode:
1. From the Home screen, select
Simulator.
2. Select
Setup
to set speed, track control, and position.
Viewing System Information
You can view the software version, the basemap version,
supplemental map information (if applicable), the unit ID number
for your chartplotter, and your XM
ID (if available). You may need this information to update the
system software or to purchase additional map data information.
From the home screen, select
information.
restoring the Original Factory Settings
NOTE: This procedure deletes all settings information you have
entered.
1. From the Home screen, select
Information
Factory
Settings.
>
2. Select
Yes
to restore all factory settings, or select
The unit reboots and prompts you to adjust unit settings
Configure
>
System
>
WX Satellite Weather
®
®
Configure
>
System
>
System
Configure
>
System
>
System
no
to cancel.
Inserting and removing SD Cards
Your unit supports Secure Digital (SD) cards. Insert optional
BlueChart
g2 Vision
®
imagery and aerial reference photos of ports, harbors, marinas
and other points of interest. Use SD cards to transfer data such as
waypoints, routes, and tracks to another compatible Garmin unit or
a computer
(page
corner of the unit.
Radio
To insert the SD card, open the access door and press the SD card in
until it clicks. Press the card in again and release it to eject it from
the chartplotter.
(page
3).
SD cards to view high-resolution satellite
®
45). The SD card slot is located on the lower-right
GPSMAP 400/500 Series Owner's Manual