Maintenance; Cleaning And Care; Repairs; What To Do If - Gastro-Cool GCGW50 Instructions For Use Manual

10 Maintenance

10.1 Cleaning and care
If the appliance requires cleaning, proceed as follows:
1. Before beginning with repair or cleaning works, make sure the device
has been disconnected from the power socket (pull the power plug!)
and has cooled down.
2. Clean the interior (including the rear wall and bottom) with warm water
and a mild cleaning agent. Do not use any aggressive cleaning agents!
3. Dry all surfaces carefully.
4. After cleaning, reconnect the refrigerator to the mains supply.
5. Never clean the appliance with steam cleaning equipment.
6. Regularly clean the refrigerator and also check the condensation water drain.
7. If the light is damaged, it must be replaced by the manufacturer or its
service agent with a light of the same size, power and shape.
8. We recommend annual cleaning of the condenser to maintain performance.

11 Repairs

WARNING:
Repairs to electrical equipment may only be
!
carried out by our customer service.
Any repairs carried out incorrectly or unprofessionally put
the user at risk and lead to the warranty becoming invalid!
!
WARNING:
Do not damage or interrupt the refrigerant circuit.
WARNING:
Do not store electrical appliances inside the
!
food storage compartments of the appliance, unless they are
of the type recommended by the manufacturer.
38
12 What to do if... troubleshooting
The design of the appliance guarantees interruption-free operation and a long
service life. However, if a fault does occur during operation, check whether it can
be traced back to an operating error.
You can eliminate the subsequent faults by yourself by checking the possible
causes:
Fault Possible Causes
The appliance is Is the mains plug in the
not cooling. socket?
Has the fuse in the socket
been triggered?
The appliance Is the appliance aligned
is noisy when vertically and horizontally?
operating.
Water is pooling Has the temperature
at the bottom of regulator been set correctly?
the refrigerator.
Is the condensation
waterdrain blocked by dirt?
Is the condensation drain
blocked by bottles on the
bottom?
The appliance Is the appliance ventilation
is not cooling blocked?
correctly.
Wet panes. Is the device temperature
set too cold?
Is the humidity in the unit too
high?
Measures
Insert the mains plug correctly
in the mains socket, switch on
the fuse, if required call for
expert assistance.
Adjust the appliance using the
supports.
Flow noises in the refrigerant
circuit are normal.
Correct the temperature
regulator setting.
Clean the drain with a pipe
cleaner or a small brush.
Place the bottles on a shelf.
Clear the ventilation slot,
position the appliance with
sufficient space.
Set the temperature slightly
higher.
39