Noises During Operation; Defrosting / Switching Off; Maintenance; Cleaning And Care - Gastro-Cool Bag-In-Box GCBIB110 Instructions For Use Manual

The table below displays the temperatures of the different levels.
The temperature display relates to the lower level.
Level Temperature (°C)
Upper 10 11 12
Centre 2 3 4
Lower 0 1 2
noTE
Please note that the temperature will change depending on the
ambient temperature (installation site), the frequency of opening
the door and the fittings.
IMPoRTAnT
high room temperatures (such as e.g. on hot summer days)
and a cold temperature setting can lead to continuous
refrigerator operation. The reason for this is that the
compressor has to run continuously in order to maintain the
low temperature in the appliance. The appliance is not able
to defrost automatically because this is only possible when
the compressor is not running (see the defrosting section).
Therefore, a thick layer of frost or ice may form on the rear
interior wall.

9.3 noises during operation

normal noises
• Humming – the noise is caused by the compressor during operation.
It is loud when it switches on or off.
• Liquid noise – caused by the refrigerant circulating in the unit.
• Clicking noises – the temperature regulator switches the compressor
on or off.
Distracting noises
• Vibration of the grill or the cooling coils – check to make sure that
they are correctly attached.
34
13 14 15 16 17 18 19
5 6 7 8 9 10 11
3 4 5 6 7 8 9

10 Defrosting / Switching off

During the cooling and defrosting phases a thin layer of ice or drops
of water form on the inner wall. The condensation water flows into
20 a collecting tray and evaporates. Please ensure that the outflow
12
channel is not blocked. It can be cleaned carefully with a pipe cleaner.
10
Your refrigerator does have automatic defrosting, but if a thicker
layer of ice forms in-side the appliance – if you occasionally defrost it
by hand – proceed as described under point 11.1. Optionally, in order
to accelerate defrosting you can place a bowl with hot water in the
appliance or use a hairdryer.

11 Maintenance

11.1 cleaning and care

If the appliance is dirty, proceed as follows:
1. Disconnect the refrigerator from the mains supply.
2. Clean the interior (including the rear wall and bottom) with warm
water and a mild cleaning product. Do not use any aggressive
cleaning products!
3. Dry all surfaces carefully.
4. After cleaning reconnect the refrigerator to the mains supply.
5. Never clean the appliance with steam cleaning equipment.
6. Also check the condensation water outflow hole.
35