Refrigerant; Installation; Positioning; Levelling - Gastro-Cool GCGW50 Instructions For Use Manual

Mini freezers
Hide thumbs Also See for GCGW50:
Table of Contents

Advertisement

Available languages

Available languages

5.1

Refrigerant

BEWARE
!
The refrigerant circuit of the appliance contains the refrigerant
isobutane (R600a), a highly environmentally compatible
natural gas that is inflammable. While transporting and installing
the appliance, ensure that no parts of the refrigerant circuit
are damaged.
Procedure if the refrigerant circuit is damaged:
• Avoid open fire and ignition sources at all costs
• Ensure that the room in which the appliance is located is well ventilated

6 Installation

6.1 Positioning

The appliance should be located in a well-ventilated and dry room. The
ambient temperature affects the power consumption and correct function of
the appliance.
Sufficient air circulation on the rear wall and upper edge of the appliance
must be guaranteed. For optimal ventilation of the appliance, the minimum
ventilation cross-sections must be observed: position the refrigerator at least
100 mm away from the wall; furthermore a space of 20 mm must be left to the
right and to the left, and 300 mm at the top. use the appliance on a firm and
smooth surface.
IMPORTANT
• The appliance must not be exposed to direct solar radiation.
• The appliance must not be placed close to heaters, next to a stove
or other heat sources.
• The appliance must be positioned so that the mains plug is accessible.
• The appliance may only be placed in a location where the ambient
temperature corresponds to the climate classification for which the
appliance is designed.
34
This unit is designed to operate in climates where the maximum temperature
ranges from 16 to 32 °C and the maximum humidity is 70%.
6.2

Levelling

If the bearing surface is uneven, the appliance can be balanced using the front
supports. Rotate the support (34) until the appliance stands firmly on the ground
horizontally and without wobbling.
34
7

Start-up

7.1 Before starting up for the first time
After transportation, the appliance should be left to stand for at least 24 hours
so that the refrigerant can separate from the appliance oil and collect in the
compressor. Non-observance of this may damage the compressor and lead to the
appliance malfunctioning. In such a case the warranty becomes invalid.
Clean the interior of the refrigerator and all of the accessories to be found here with
commercially available, mild cleaning products.
WARNING: Do not store explosive substances such as aerosol
!
cans with a flammable propellant in this appliance.
CAUTION: Please ensure that the bottom of appliance is not covered by bottles
to avoid disrupting the condensation drain. It is best to put the bottles on a shelf.
The shelf can withstand the maximum load 18 kg.
35

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Gcdf72542400542200543200

Table of Contents