Error Code Display - Honda EU7000is Manual

AC OUTPUT
High voltage and electrical current present. Touching the non-insulated portions
of the meter leads or generator wiring can cause shock or electrocution.
Wear insulated gloves and avoid handling non-insulated wiring.
Use a load bank (available through the Honda Tool and Equipment Program or the Parts Division) to verify the customer's
initial complaint and the generator's performance after the repairs (see
COMPLAINT: Abnormal output (none, low, or high) at receptacle. Normal: 120 VAC ± 10.
The circuit protectors must be in the ON position.
1. Does the engine start and run, or stop
shortly after it is started?
RUNS
2. Start the engine
and verify that
the output
indicator is ON.
OUTPUT
INDICATOR
OFF
3. With a fully charged battery installed, turn the engine switch to the ON position.
4. Push and hold the i-Monitor button for 3 seconds. If an error
code (E-XX) is displayed, record the code. Push the
i-Monitor button again and record additional codes until END
appears.
NO CODE
5. Start the engine and verify the engine speed.
Specified engine speed:
®
Eco Throttle OFF: 3,300
Eco Throttle ON: 2,400
OK
Proceed to step 6 on the next page.
EU-90

STOPS
ON
I-MONITOR
BUTTON
ERROR CODE
DISPLAY
±
100 rpm
±
100 rpm
WARNING
page 3-2).
Go to step 3.
• Check the receptacles.
• Check the circuit
protectors.
• Check the voltage
selector switch.
• Check the wiring from
the inverter to the control
panel.
OK
CODE(S)
NG
© 1998-2021 American Honda Motor Co., Inc.—All Rights Reserved
Troubleshoot the most recent error
code(s) according to the itemized
list starting on page EU-93.
Use the EU7000is i-Monitor Detail
Error Log located in the TEST
WORKSHEETS chapter of this
manual to record error codes and
the detail error log information for
each error code.
Refer to Hard Starting in the shop
manual Troubleshooting Section.
Date Revised: March 2021 (PSV52522-S)