Table of Contents
Advertisement
Data Flow and Operation Options
DT9850 Series
Single-Value Operation Support
SupportsSingleValue
Simultaneous Single-Value Output Operations
SupportsSetSingleValues
Continuous Operation Support
SupportsContinuous
Continuous Operation until Trigger
SupportsContinuousPreTrigger
Continuous Operation before & after Trigger
SupportsContinuousPrePostTrigger
Waveform Operations Using FIFO Only
SupportsWaveformModeOnly
Simultaneous Start List Support
SupportsSimultaneousStart
Supports Programmable Synchronization Modes
SupportsSynchronization
Synchronization Modes
SynchronizationMode
Interrupt Support
SupportsInterruptOnChange
FIFO Size, in Samples
FifoSize
Muting and Unmuting the Output Voltage
SupportsMute
Auto-Calibrate Support
SupportsAutoCalibrate
a. You can also update multiple channels simultaneously with a single value by using the DAC_Sync pin. Refer to
page 55
for more information.
b. The digital input port can operate in continuous digital input mode if you enabled interrupt usage for this port in
the driver configuration dialog box (see
this port changes state. If you are using the DataAcq SDK, refer to
which digital input lines changed state.
Table 8: Data Flow and Operation Options
A/D
page
27). The software generates an event when digital input line 0 to 6 of
D/A
DIN
DOUT
Yes
Yes
Yes
Yes
a
Yes
b
Yes
Yes
Yes
b
Yes
0
page 60
for more information about determining
Supported Device Driver Capabilities
C/T
TACH
QUAD
65
Advertisement
Table of Contents
