Installation And Attachment - Peakworks Tank Trolley Installation, Operation & Maintenance Manual

3.0

Installation and Attachment

3.1 Anchorage Structure: Confirm that the anchorage structure (tank)
meets strength requirements listed in section 1.0.
3.2 Inspect trolley as instructed in the inspection section. Attach Tank
Trolley TM as shown. Make sure that the bearings roll smoothly along
the top of the structure and that "THIS SIDE UP" warning labels are
pointing up. Do not expose yourself to a fall hazard during attachment
or detachment. Never attach the Tank Trolley
Product
Labels
3.3 Connect fall protection deceleration device to the O-ring using a
double locking snap hook or carabiner.
3.4 Clearance: Determine the necessary clearance needed below the
walking or working surface and confirm that adequate clear space is
available. Read instructions provided with the fall protection
deceleration device you will be using for clearance information.
WARNING!
Do not attach more than one snap hook or carabiner to the O-ring.
Do not attach more than one person to a trolley.
Connect only to the side of the trolley that you are working on.
Never work on the opposite side of the trolley.
4.0 Operating Instructions
4.1 You must follow these instructions carefully to allow this system to
provide you with needed fall protection during the job. If you have any
concerns regarding the condition of the system or experience any
problems, notify your supervisor or the safety department immediately.
Never take any chances.
INST-TT, rev. 8
TM in any other manner.
Printed in the U.S.A. Page 4 of 8