Package Contents; Assembly And Adjustments - DeWalt XR DCD740 Original Instructions Manual

EnGLIsH

Package Contents

The package contains:
1 Drill
1 Charger
1 Battery
1 Kitbox
1 Instruction manual
nOTE: Battery packs, chargers and kitboxes are not included
with N‑models.
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
a
Read instruction manual before use.
g
Wear ear protection.
f
Wear eye protection.
n
Visible radiation. Do not stare into light.
Date Code Position (Fig. B)
The date code 13 , which also includes the year of manufacture,
is printed into the housing.
Example:
2021 XX XX
Year and Week of Manufacture
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Paddle switch
1
Forward/reverse control button
2
Gear shifter
3
Deep hex pocket
4
Worklight
5
Belt hook
6
Mounting screw
7
Bit clip
8
Battery pack
9
Battery release button
10
Chuck with deep hex pocket
11
Intended Use
These drills are designed for professional drilling and
screwdriving applications.
DO nOT use under wet conditions or in presence of flammable
liquids or gases.
32
These drills are professional power tools. DO nOT let children
come into contact with the tool. Supervision is required when
inexperienced operators use this tool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.

WARNING: Use only D
Inserting and Removing the Battery Pack
from the Tool (Fig. B)
nOTE: Make sure your battery pack
To Install the Battery Pack into the Tool Handle
1. Align the battery pack 9
handle (Fig. B).
2. Slide it into the handle until the battery pack is firmly seated
in the tool and ensure that you hear the lock snap into place.
To Remove the Battery Pack from the Tool
1. Press the battery release button
battery pack out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
Fuel Gauge Battery Packs (Fig. B)
Some D WALT battery packs include a fuel gauge which
e
consists of three green LED lights that indicate the level of
charge remaining in the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge
button 14 . A combination of the three green LED lights will
illuminate designating the level of charge left. When the level
of charge in the battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to be recharged.
nOTE: The fuel gauge is only an indication of the charge left on
the battery pack. It does not indicate tool functionality and is
subject to variation based on product components, temperature
and end‑user application.
Variable Speed Paddle Switch (Fig. A)
To turn the tool on, squeeze the paddle switch
tool off, release the paddle switch. Your tool is equipped with
a brake. The chuck will stop as soon as the paddle switch is
fully released.
The variable speed switch enables you to select the best speed
for a particular application. The farther you squeeze the paddle,
WALT battery packs and chargers.
e
9 is fully charged.
with the rails inside the tool's
10 and firmly pull the
1 . To turn the