Ezviz DB2 Pro Manual page 3

2. Basics
Doorbell
Name Description
LED Indicator • Solid Red: Person detected and less than 20% of battery/doorbell
button pressed and less than 20% of battery.
• Slow-Flashing Red: Charging.
• Solid Blue: Person detected or doorbell pressed/fully charged/more
than 20% battery left.
Power Button • Short press for 1 second: Turn on the doorbell.
• Long press for 5 seconds: Turn off the doorbell.
Chime
LED Indicator
Name Description
LED Indicator • Solid Red: Chime is starting up.
• Fast-Flashing Red: Disconnected from the doorbell or SD card error.
• Slow-Flashing Red: Wi-Fi connection has failed.
• Solid Blue: Chime is functioning properly.
• Fast-Flashing Blue: Chime is ready for Wi-Fi connection.
Reset Button Hold the reset button for 5 seconds and if the doorbell beeps once,
indicating that the reset is successful and all parameters will be reset
to default.
Setup
It is recommended to place the chime within 4 meters from where the doorbell is
installed.
1. Power-on
1. Short press the power button for 1 second to turn on the doorbell.
The doorbell LED indicator goes out after turning blue for 3 seconds, indicating
that the doorbell is turned on.
PIR
Lens
Power Port
Light Sensor
(Do Not Block)
LED Indicator/
Doorbell Button
2
Terminals
Power Button
Dismantle Hole
Antenna
Micro SD Card Slot
RESET Button