If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) Your BLACK+DECKER BDCIM18 - Impact Screwdriver has protected supply. Use of an RCD reduces the risk of been designed for screwdriving applications and for drilling in electric shock.
Page 4
ENGLISH (Original instructions) c. Disconnect the plug from the power source and/or e. Do not use a battery pack or tool that is damaged or remove the battery pack, if detachable, from the power modified. Damaged or modified batteries may exhibit tool before making any adjustments, changing unpredictable behaviour resulting in fire, explosion or risk accessories, or storing power tools.
(Original instructions) ENGLISH and when it is running idle in addition to the trigger time. Warning! Impact wrenches are not torque wrenches. Do not use this tool for tightening Labels on tool fasteners to specified torques. An independent, The following symbols are shown on the tool along with the calibrated torque measurement device such as date code: a torque wrench should be used when under...
Page 6
ENGLISH (Original instructions) If the supply cord is damaged, it must be replaced by the done before. The battery may become warm while charging; manufacturer or an authorised BLACK+DECKER Service this is normal and does not indicate a problem. Warning! Do not charge the battery at ambient temperatures Centre in order to avoid a hazard.
Further information is available at www.2helpU.com Hints for optimum use Technical data Drilling BDCIM18 (H1) Always apply a light pressure in a straight line with the drill bit. Voltage Just before the drill tip breaks through the other side of the...
18.1 m/s , uncertainty (K) 1.5 m/s EC declaration of conformity MACHINERY DIRECTIVE BDCIM18 - Impact Screwdriver BLACK+DECKER declares that these products described under “technical data” are in compliance with: 2006/42/EC, EN62841-1:2015, EN62841-2-2:2014. These products also comply with Directive 2014/30/EU and 2011/65/EU.