Switching From Steam To Coffee; Dispensing Hot Water; Preparing Cappuccino; Dispensing Steam - Gaggia SYNCRONY DIGITAL Operating Instructions Manual

ENGLISH
In this way, the appliance will be programmed
to brew the quantity of coffee you selected.
8

DISPENSING HOT WATER

Caution: hot sprays may be
discharged at the start – scalding
hazard! The hot water nozzle and tube can
reach high temperatures: avoid touching
them directly with your hands.
• Before attempting to dispense hot water, make
sure that the display shows.
SELECT PRODUCT
READY FOR USE
When the machine signals that it is ready to
brew coffee, carry out the following steps.
• Place a cup and/or receptacle beneath the
hot water/steam nozzle (Fig.09).
• Turn the knob anticlockwise as shown in
Fig.09. The display will show:
HOT WATER
• Dispense the desired quantity of hot water; to
stop the flow of hot water turn the knob
clockwise. The display will show:
SELECT PRODUCT
READY FOR USE
9 DISPENSING

PREPARING CAPPUCCINO

Steam can be used to froth the milk
for cappuccinos and also to heat
beverages.
Scalding hazard!
Hot sprays may be discharged at the
start – scalding hazard! The hot water nozzle
and tube can reach high temperatures:
avoid touching them directly with your
hands.
• When the machine is ready to brew coffee,
press the button (26). The machine will take
some time to warm up.
During this time the display will show:
• When the machine is ready to dispense steam,
the display will show:
• Direct the steam tube (14) over the drip tray
(12), place a cup or other suitable receptacle
beneath the steam nozzle. Open the "Hot
water/steam" knob (16) for a few instants to
discharge any residual water from the steam
nozzle; in a short while only steam will issue
from the tube.
• Turn the knob (16) to OFF.
• Fill the receptacle you wish to use for making
cappuccino to 1/3 with cold milk.
used should be cold.
• Immerse the steam nozzle into the milk to be
frothed and turn the knob (16); turn the
container slowly with up-down movements
to achieve uniform frothing (Fig.10).
• After using the steam for the desired time, shut
off the steam (16).
• The same method can be used to heat other
beverages.
STEAM /
• Clean the steam nozzle with a damp cloth .
• When you have finished dispensing steam, turn
off the function by pressing the button (26).

9.1 Switching from steam to coffee

• When you switch from the steam dispensing
function to the coffee brewing function, the
display will show:
the machine is overheated and cannot make
coffee.
• In order to make coffee, you must discharge
• 32 •
STEAM
WARMING UP
STEAM
READY FOR USE
For best results when making
cappuccinos, the milk and the cup
OVERTEMPERATURE