Graco Line Lazer 3500 Instructions-Parts List

INSTRUCTIONS-PARTS LIST
This manual contains important
warnings and information.
READ AND KEEP FOR REFERENCE.
INSTRUCTIONS
Kits, Line Guide
Line Lazer 3500, 5000
Line Lazer II 3900, 5900
Model 241101, Series A (short) and
Model 241102, Series A (long)
Installation
4X .330
Thru. Both Walls
1.0 in
Fig. 1
NOTE: Steps 1 and 2 apply to LineLazer 3500 and
LineLazer 5000 only.
1. Drill two holes on both sides of chassis frame as
shown in Fig. 1.
2. Fig. 2. Mount one bracket (6) on right side of
chassis (viewed from front) with two flange screws
(7) and two lock nuts (8).
NOTE: Steps 3 and 4 apply to all LineLazers.
3. Slide bracket (6) on rod (1). Note bracket orienta-
tion. Insert rod in bracket mounted on right side.
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441
1.0 in
Front
5.55 in
8851A
COPYRIGHT 1999, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001
First choice when
quality counts.
4. Mount second bracket (6) on left side of chassis
(viewed from front) with two flange screws (7) and
two lock nuts (8).
6
8
7
Fig. 2
Operation
For new stripes:
The dual point guide allows for line placement on the
same side of layout string or chalk, traveling either
direction. Center the pointer on the center of paint
guns and when painting alternate between points for
each direction traveled.
1. Put line guide in down position to paint.
2. When finished store line guide in up position.
308941
Rev. A
8850A
6,7,8
1
8850A