Installation; Trane Wall Sleeve And Grille; Considerations For Use Of Existing Sleeves - Trane ProSpace PTEF Installation, Operation And Maintenance Manual

Installation

Trane Wall Sleeve and Grille

The image below shows the typical unit components that are ordered and installed.
I I m m p p o o r r t t a a n n t t : : Proper installation is the responsibility of the installer. Product failure due to
To install the Trane Wall Sleeve and Grille, refer to the latest installation instructions, PTAC-SVN-
028 and PTAC-SVN027.

Considerations for Use of Existing Sleeves

I I m m p p o o r r t t a a n n t t : : For retrofit applications, foam seals on outdoor coil tube sheets must make a seal
L L i i v v e e E E l l e e c c t t r r i i c c a a l l C C o o m m p p o o n n e e n n t t s s ! !
F F a a i i l l u u r r e e t t o o f f o o l l l l o o w w a a l l l l e e l l e e c c t t r r i i c c a a l l s s a a f f e e t t y y p p r r e e c c a a u u t t i i o o n n s s w w h h e e n n e e x x p p o o s s e e d d t t o o l l i i v v e e e e l l e e c c t t r r i i c c a a l l
c c o o m m p p o o n n e e n n t t s s c c o o u u l l d d r r e e s s u u l l t t i i n n d d e e a a t t h h o o r r s s e e r r i i o o u u s s i i n n j j u u r r y y . .
W W h h e e n n i i t t i i s s n n e e c c e e s s s s a a r r y y t t o o w w o o r r k k w w i i t t h h l l i i v v e e e e l l e e c c t t r r i i c c a a l l c c o o m m p p o o n n e e n n t t s s , , h h a a v v e e a a q q u u a a l l i i f f i i e e d d l l i i c c e e n n s s e e d d
e e l l e e c c t t r r i i c c i i a a n n o o r r o o t t h h e e r r i i n n d d i i v v i i d d u u a a l l w w h h o o h h a a s s b b e e e e n n p p r r o o p p e e r r l l y y t t r r a a i i n n e e d d i i n n h h a a n n d d l l i i n n g g l l i i v v e e e e l l e e c c t t r r i i c c a a l l
c c o o m m p p o o n n e e n n t t s s p p e e r r f f o o r r m m t t h h e e s s e e t t a a s s k k s s . .
In applications when the unit is a replacement, it is recommended to use a Trane sleeve. This unit
can be retrofitted to other manufacturers similar sleeves if outdoor unit airflow is not restricted or
recirculated.
N N o o t t e e : : Ensure the outdoor grille is installed on the sleeve. For any sleeve retrofit applications, be
PTAC-SVX002A-EN
improper installation is not covered under warranty.
between the coil and the grill or loss of performance and premature damage to the
major components can result.
sure that the foam seals (factory installed on the tube sheets) provide a good seal between
the grille and outdoor coil tube sheets. These foam seals provide a barrier that stops the
inside air from mixing with the outside air (known as air recirculation).
W W A A R R N N I I N N G G
13