Environmental And Operating Conditions; Personnel Qualification - SCHUNK VERO-S WDM-5X Series Assembly And Operating Manual

2.5 Environmental and operating conditions

2.6 Personnel qualification

Trained electrician
Qualified personnel
Instructed person
Service personnel of
the manufacturer
Required ambient conditions and operating conditions
Incorrect ambient and operating conditions can make the product
unsafe, leading to the risk of serious injuries, considerable material
damage and/or a significant reduction to the product's life span.
• Make sure that the product is used only in the context of its defined
application parameters,
• Make sure that the product is a sufficient size for the application.
• Make sure that the contact surfaces of the interface are always
clean.
• Make absolutely sure that no chips of any kind can enter the
interface and that the interface does not fill with cooling emulsion,
which is particularly possible with vertical positioning of the
clamping pin axis. The best way to ensure both of these is to use
the SDE protection covers. If the interface should fill with cooling
emulsion, initiate the unlocking process and dry out the interface in
actuated state.
• Only use high-quality cooling emulsions with anti-corrosive
additives during processing.
Inadequate qualifications of the personnel
If the personnel working with the product is not sufficiently qualified,
the result may be serious injuries and significant property damage.
• All work may only be performed by qualified personnel.
• Before working with the product, the personnel must have read
and understood the complete assembly and operating manual.
• Observe the national safety regulations and rules and general
safety instructions.
The following personal qualifications are necessary for the various
activities related to the product:
Due to their technical training, knowledge and experience, trained
electricians are able to work on electrical systems, recognize and avoid
possible dangers and know the relevant standards and regulations.
Due to its technical training, knowledge and experience, qualified
personnel is able to perform the delegated tasks, recognize and avoid
possible dangers and knows the relevant standards and regulations.
Instructed persons were instructed by the operator about the
delegated tasks and possible dangers due to improper behaviour.
Due to its technical training, knowledge and experience, service
personnel of the manufacturer is able to perform the delegated tasks
and to recognize and avoid possible dangers.
01.00 | WDM-5X | VERO-S modular system for manual workpiece direct
clamping | en | 1504808
} 3 [/ 15].
Basic safety notes
9