Table of Contents
Advertisement
2.8.1 Holding force and screw strength
The holding force of the System is essentially limited by the strength
of the screwed connections with which the clamping pin is
connected to the pallet or device. On this basis fastening screws of
the property class 12.9 are to be used only.
Only original SCHUNK Clamping-Pins are to be used.
When the clamping pin is used in the customer's own assembly
device, the customer is to provide for a sufficiently dimensioned tap
and satisfactory strength of the fastening material.
2.9 Transport
Handling during transport
Incorrect handling during transport may impair the product's safety
and cause serious injuries and considerable material damage.
• When handling heavy weights, use lifting equipment to lift the
product and transport it by appropriate means.
• Secure the product against falling during transportation and
handling.
• Stand clear of suspended loads.
2.10 Malfunctions
Behavior in case of malfunctions
• Immediately remove the product from operation and report the
malfunction to the responsible departments/persons.
• Order appropriately trained personnel to rectify the malfunction.
• Do not recommission the product until the malfunction has been
rectified.
• Test the product after a malfunction to establish whether it still
functions properly and no increased risks have arisen.
01.00 | WDM-5X | VERO-S modular system for manual workpiece direct
clamping | en | 1504808
Basic safety notes
11
Advertisement
Table of Contents
