Verizon CME1000 User Manual page 33

WI-FI PROTECTED SETUP
• Click Register
• Alternatively, you can enter the router's PIN shown on
this screen into the WPS user interface of your device, if
this PIN mode is supported by your Wi-Fi device.
3. After pressing the WPS button on your Mini Extender, you
have two minutes to press the WPS button on the client
device before the WPS session times out.
When the WPS button on your Mini Extender is pressed,
the Status LED on the front of your Mini Extender begins
flashing blue. The flashing continues until WPS pairing to the
client device completes successfully. At this time, the Status
LED turns solid white.
If WPS fails to establish a connection to a Wi-Fi client device
within two minutes, the Status LED on your Mini Extender
flashes red for two minutes to indicate the WPS pairing
process was unsuccessful. After flashing red, the light
returns to solid white to indicate that Wi-Fi is on.
Note: Wi-Fi Protected Setup (WPS) cannot be used if WPA3
security is enabled or SSID broadcast is disabled or if MAC
address authentication is enabled with an empty white list.
Register.