Displays2go FDWMDWBBRN Assembly Instructions

ASSEMBLY INSTRUCTIONS
Wall-Mounted Folding Desk
SKU: FDWMDWBBRN
1. Mark the required height of the wall-mounted desk. Place
the Z-bar (C) on the wall and mark the center of each hole. Drill
2 pilot holes (6mm) at marked location with power drill.
From ground to higher Z-bar: 39.25"
From ground to lower Z-bar: 29"
NOTE: Use a bubble level to
help to keep the Z-bar level.
2. Insert 1 Plastic Wall Anchor (A) into each pilot hole on
the wall. Use a rubber mallet to tap them flush with the wall.
A
Plastic Wall
Anchor
B
Screw
320mm[12.6]
56.339"
27.874"
28.465"
Wall
A

HARDWARE

C
4 pcs
4 pcs
3. Place the Z-bar (C) against the wall as shown and fix
it with the 2 enclosed Screws (B).
4. Carefully lift up the foldable desk above the mounted
Z-bar. Push the unit against the wall and slowly lower the unit
onto the Z-bar. Check the desk and make sure it's mounted
securely
Wall
Z-bar 4 pcs
Wall
Desk
Wall
Ver. 07.21
C
B
Wall
Desk
1 of 2