4: Hardware Maintenance Information; Customer Replaceable Unit Part Numbers; Shipping And Service - IBM 3U Extend Run Operation And Setup Manual

4: H M
ARDWARE

Customer Replaceable Unit Part Numbers

IBM CRU part numbers are subject to change without notice.
This section contains a listing of the CRU part numbers available at the time this document was published.
I CRU P
NDEX ART

25R5588

46M5386

25R5995

73P5769

25R5600

25R5597

Shipping and Service

Prepare the uninterruptible power supply for shipping:
Shut down and disconnect any equipment attached to the uninterruptible power supply. Shut down the uninterruptible power supply,
and disconnect the uninterruptible power supply from the utility power outlet. Remove the front bezel and disconnect the batteries.
If the uninterruptible power supply requires service, do not return it to the dealer. Follow these steps:
1. Review the problems discussed in Troubleshooting to eliminate common problems.
2. If the problem persists, contact IBM.
•
Note the model number of the uninterruptible power supply, the serial number, and the date purchased. If you call IBM
Customer Service, a technician will ask you to describe the problem and attempt to solve it over the phone, if possible. If the
uninterruptible power supply or one of its components is faulty, IBM will send you a replacement CRU for the
uninterruptible power supply or the component.
•
If the uninterruptible power supply or the component is under warranty, repairs are free. If not, there is a repair charge.
3. Pack the uninterruptible power supply or the faulty component in packaging sent by IBM, and use the return label to ship back to
IBM. Pack the uninterruptible power supply properly to avoid damage in transit. Never use Styrofoam beads for packaging.
Damage sustained in transit is not covered under warranty.
A : A
TTENTION LWAYS DISCONNECT THE BATTERY BEFORE SHIPPING
UNINTERRUPTIBLE POWER SUPPLY
I
AINTENANCE NFORMATION
#
Extend Run Battery Pack Chassis
Replacement Battery Module
Front Bezel
Rail Kit
Accessory Kit
Rack-to-Tower Conversion Kit
,
THEY DO NOT HAVE TO BE REMOVED
D
ESCRIPTION
. T
HE BATTERY MODULES MAY REMAIN IN THE
.
18