Castex CASC505 Manual page 12

-Clean the machine regularly after each use. Clean the Stage with detergent at least once a week and
lubricate the sliders and jaws.
- Empty the air filter from the water once a day to ensure that the cylinder is working.
At least once a month, check the oil level in the hydraulic unit. If necessary, replenish the oil condition
using: SAE30#, press the pedal 5-6 times to lock the tire, check that the oil in the hydraulic unit flows
freely, press down twice each time, lower the oil drop, tighten the screw (E) regulating the oil injection
with a screwdriver.
To extend the life of the device, maintain it systematically by following the instructions, neglect of the
device can lead to problems with its operation and damage to the body of the operator and people
nearby.
Warning: Before the above steps, disconnect the device from the mains and the air source,
press the rim break pedal 3~4 times to release compressed air from the device. (Fig.11)
Damaged parts should be replaced by qualified personnel with spare parts proposed by the
manufacturer
Note: After the first 20 days of use, tighten the jaws with clamping screws B. (Fig. 12)
Note: If you lose power, check that the strap is clamped. To do this, remove the left part of the housing
by unscrewing the screws. Tighten the strap with adjustable screws located on the motor booster. (Fig.
13)
Warning: Disconnect the device from the mains and air source.
Note: To maintain the reliability of the jaws and rim break arm, follow the instructions.
1.Remove the left side of the cover by unscrewing the screws;
2.Loosen the valve silencers (a) which are part of the jaw clamping pedal and the rim break pedal(Fig.
14)
3.Clean the silencer with compressed air and replace it with the original silencer from the spare parts
list if necessary.
Fig. 12 Fig.13 Fig.14
12