Table of Contents
Advertisement
d. The tyre is pumped at a higher pressure than recommended by the manufacturer.
e. The operator does not comply with the required safety standards.
5) Wind tires
(a) . Unscrew the valve.
B. Connect the tip to the tyre valve while making sure it is tightly coupled.
c. Make sure that the diameters on the rim and tire match.
d. Make sure that the rim and tire have been sufficiently
lubricated, Ew. Improve
That. Press the pedal halfway down to start pumping air.
F. Often release the pumping pedal to check the pressure
on the pressure gauge. Inflate the tyre with short doses until
the desired pressure is obtained
6) . Pumping of heatless tires.
Note: When pumping heatless tires, the wheel must be
fixed from the rim sirotka.
a) Unscreed the cap from the valve
b) Attach the pump to the valve, making sure that it is properly connected.
c) Check again that the rim diameter coincides with the diameter of the wheel.
d) Check that the rim and tyre are sufficiently lubricated, or correct them.
e) Press the pedal halfway down
f)
If the foot does not slip into the rim, lift the tyre with your hand until the upper foot
rests against the rim, then press the pedal down.
g) Release the tyre and lift the foot slightly on the pedal so that it can return to the
intermediate position, pump the tire until the required pressure is reached.
Note::
1) Follow the instructions in the manual to avoid an accident.. Improper handling of the device
can result in serious injury and even death of the device operator. Under no circumstances
exceed the pressure limit of 3.5 bar when seating the rim and pumping the tire.
2) If a pressure greater than the above is required, remove the tyre from the mounting device
and continue pumping the wheel in a specially designed cage. NEVER exceed the tyre
manufacturer's pressure.
3) Keep your hands and other body parts away from the inflated tire.
4) The device can only be operated by qualified personnel.
14. Storage
If the appliance is not to be used for an extended period of time, disconnect it from the electrical
supply and the air source. Lubricate all parts that require it: slider, slider hole, horizontal arm slot. Empty
the box of oil and water, cover with a plastic cover to avoid contamination of the device.
15. Maintenance
Note: All maintenance may only be carried out by qualified personnel after the device plug
has been previously disconnected from the mains.
1) Disconnect the device from the mains.
2) Disconnect the air source.
Follow the instructions:
Fig. 27
Fig. 11
11
11
Advertisement
Table of Contents
